You are here:

Retrieving Studies Configured for Enhanced Display

Introduction

Synapse provides you with the ability to retrieve studies that are disabled (grayed out) on an initial load, from an external server configured for Enhanced Display.

Note:

If a study receives new images on the datasource, configured for Enhanced Display, the image count in the Worklist and PowerJacket reflects receipt of the additional images. To access the new images, you will need to reopen the study after the cached images are cleared from dicomCache on the SCU server.
If you volumize a series while displaying one of the findings for an image with multiple findings, the volumized series might display the AI findings icon with an asterisk in place of the findings number. This occurs when more than one, but not all of the findings display. For example, the AI findings icon could display */4 instead of 2/4.
- Additionally, the total number of findings per slice in the 3D slice might differ when you are displaying partial findings in 3D view and then switch to 2D view.

Prerequisites

COMMONVIEW for an Enhanced Display datasource must be configured in the SWAT settings. See your System Administrator.

About this Task

If Autocompare is configured, studies that have not yet been retrieved will not be considered by the Autocompare rules until studies are retrieved and the Viewer is refreshed.

Note:

If you open a DicomSCU series with multiple sections that can be separately volumized but the sections are not already split, a dialog box opens where you can select specific sections to volumize.

Steps

Open a home study or a study on the home datasource. This study should have priors that are stored on the datasource configured for the enhanced display.
Do one of the following:
- In PowerJacket, double click a grayed out study or right-click and select Retrieve Study.
- In the Viewer Study List Grid, double click a grayed out study. When studies have fully loaded and are ready for display, they are no longer grayed out.

Results